Select the driver that matches the operating system of your PC from the list presented on this page. Find help on http: After the search completes, the system may display the following dialog box. Page 8 After the MTa is used for a certain period of time, the cover will be heated, which will not affect the function of the MTa. Data is being transmitted through the Ethernet Blinking interface. Step 8 Click Continue Anyway to continue with the installation. MTa, both PCs can access the Internet.
In this context, it is the Ethernet card of your computer. By pressing ‘print’ button you will print only current page. Use a pin to press the Reset button and then adal it.
Enter the Internet address of Page 26 If the problem persists, contact your service provider. Chapter 5 Other Configurations 5. Acronyms And Abbreviations 8.
Table of Contents Add to my manuals Add. When you restore the default settings, the customized data may be lost.
Huawei MT882a User Manual
The figure of the rear panel is only for your reference. Choose Set up my connection manually and click Next.
After the network connection is created, to access the network, double-click the icon for the dial-up connection, and then mmt882a Connect in the displayed dialog box. Select Activated to enable function periodical information. Table of Contents Chapter 1 Introduction Operation Requirements Operation Requirements Do not allow children to play with the device or accessories.
Make sure that an Ethernet card is installed on the computer before connecting the MT with the computer.
Use the accessories provided or authorized by the manufacturer only. After the installation completes, the system will display the following dialog box.
Add the following content: Step 6 Click Next to start the installation procedure. Log in to the Web setup page of the MT Taking Internet Explorer 6. Step 5 Add the following two configuration command lines at the end of the rc.
You can access the network after you power on the computer.
Huawei ADSL CPE Modem SmartAX MT882a with USB LAN Port
If you cannot use the PPP dialing software to dial successfully, perform further checks as follows: Using the Reset Button The steps are as follows: Click Next in the New Connection Wizard dialog box. This step will create a new Ethernet interface eth1 and configure this properties.
Table Indicators on the front panel Indicator Status If water gets into the device, disconnect the power supply immediately and unplug all the cables connected to the device.
Page 5 6 FAQs MTa, both PCs can access the Adl. The MTa is activated. Step 6 Check whether you can use the PPP dialing software to dial successfully. The system installs the driver automatically. Don’t have an account?